Round Robin Test on Normalization Method under Static Loading Condition
Oh, YJ
Graduate Student and Professor, Nuclear Engineering Dept., Seoul National University, Seoul, 151-742, Korea

Hwang, IS
Graduate Student and Professor, Nuclear Engineering Dept., Seoul National University, Seoul, 151-742, Korea

Joyce, JA
Professor, Mechanical Engineering Dept., U.S. Naval Academy, Annapolis, MD, 21402

(Received 31 October 2005; accepted 6 March 2006)

Abstract

In 2001, the normalization method was approved as ASTM Method E 1820-01 [1] for use in high loading rate J-R tests. Prior to its approval, High Rate Round Robin was conducted under the coordination of ASTM Subcommittee E08.08.02 for the verification of accuracy and reproducibility of the method. However, the results of the normalization method cannot be verified against those of other well-established methods because no other method is available in the high loading rate condition. In this round robin test, J-R curves were measured under static loading conditions for A106Gr.C nuclear piping steel by the normalization method so that results can be compared with those obtained simultaneously by the unloading compliance method. The deviation of J_Ic by normalization and differences of J_Ic values from those of the unloading compliance method were quantified. The normalization method showed J_Ic deviation up to 60 % when tested with initial a/W=0.5. In order to seek ways to reduce the deviation, both offset method and tangent method were tried for normalization analysis, but with limited improvement. These partially modified normalization methods of the offset method and tangent method decreases the deviation of J_Ic, but increases the difference from those of the unloading compliance method. More fundamental approaches are warranted for adequate improvement.

ASTM International is a member of CrossRef.
Author Oh YJ, Hwang IS, Joyce JA Title Round Robin Test on Normalization Method under Static Loading Condition Symposium , Committee: on