Investigations of Testing Methodology in Wood Abrasion Tests Promoted with Loose Abrasive Grains
Ohtani, T
Faculty of Science and Engineering, Shimane University, Matsue, Shimane, Japan.

Kamasaki, K
Graduate School of Engineering, Yokohama National University, Hodogaya-ku, Yokohama, Japan.

(Received 29 December 2003; accepted 31 May 2005)

Abstract
The wear properties for wood were examined using 2-body and 3-body abrasion tests. The testing methodologies were designed so that the results from the two methods could be compared. The results showed that the 3-body abrasive wear rate for the axial, radial, and tangential sections dispersed at higher applied surface pressures. As a result, the 3-body abrasion test did not wear continuously, unlike the 2-body abrasion test at equivalent applied surface pressures. The critical value below which the 3-body abrasion test is valid could be estimated by the applied surface pressure and the wood specimen's and the counterface material's yield stresses. The number of contacting abrasive grains in the valid region of the 3-body abrasion test was found to agree approximately with that of 2-body abrasion. However, when the 3-body abrasion test was conducted above the critical value, the number of contacting abrasive grains decreased with repeated friction.

Keywords:
2-body abrasion, 3-body abrasion, abrasive wear, applied surface pressure, critical condition, loose abrasive grains, wear rate, wood, wood abrasion, wood abrasion tests, yield stress

Paper ID: JTE12530
DOI: 10.1520/JTE12530

ASTM International is a member of CrossRef.
Author Ohtani, T Affiliation Faculty of Science and Engineering, Shimane University, Matsue, Shimane, Japan. Author Kamasaki, K Affiliation Graduate School of Engineering, Yokohama National University, Hodogaya-ku, Yokohama, Japan. Author Ohtani T, Kamasaki K Title Investigations of Testing Methodology in Wood Abrasion Tests Promoted with Loose Abrasive Grains Symposium , Committee on