Liquid Extraction Using Prefabricated Vertical Wells (PVWs) Under Vacuum in Clay
ASTM International

Books & Journals/Geotechnical Testing Journal/Citation Page/

Volume 28, Issue 4 (July 2005)

ISSN: 0149-6115
Published Online: 11 May 2005
Page Count: 8

Click here to download this paper now

View License Agreement

Liquid Extraction Using Prefabricated Vertical Wells (PVWs) Under Vacuum in Clay
Warren, KA
University of Arkansas, Fayetteville, AR

Gabr, MA
North Carolina State University, Raleigh, NC

(Received 28 July 2003; accepted 17 November 2004)

Abstract
A large-scale clay specimen was prepared in the laboratory using select soil to simulate WIDE technology using a geosynthetic wick drain. While a full-scale field test is necessary to quantify system flow and contaminant removal rates using WIDE technology, laboratory work is necessary to investigate flow phenomenon local to each PVW. Two methods were developed to measure the consistency of the water content and unit weight distribution for quality control purposes. Specimen preparation techniques, flow rates, settlement, piezometer, and tracer test concentration data were measured. The radius of influence, maximum extraction depth, and potential effects of long term PVW performance were discussed. The radius of influence ranged from 0.3 to 0.4 m. Due to the band shape of the PVW, the radius of influence and extraction depth were maximized near the center of the 100-mm-wide dimension, and flow efficiency was reduced near the corners of the PVW due to the decrease in PVW surface area near the 4-mm dimension. Subsequent to laboratory testing, portions of the geotextile filter jacket were utilized to determine the decrease, if any, in permeability. While there appeared to be a 14% reduction in geotextile permeability during the test interval, soil particles also existed within the flow channels of the PVW core, indicating that long-term PVW efficiency may be a concern and needs further consideration.

Keywords:
Clay, geosynthetics, laboratory, prefabricated vertical drain, preparation, PVD, PVW, slurry, Well Injection Depth Extraction, wick drain, WIDE

Paper ID: GTJ12113
DOI: 10.1520/GTJ12113

ASTM International is a member of CrossRef.
Author Warren, KA Affiliation University of Arkansas, Fayetteville, AR Author Gabr, MA Affiliation North Carolina State University, Raleigh, NC Author Warren KA, Gabr MA Title Liquid Extraction Using Prefabricated Vertical Wells (PVWs) Under Vacuum in Clay Symposium , Committee on

 
Copyright © 1996-2007 ASTM. All Rights Reserved.
ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA, 19428-2959 USA