A Comparative Evaluation of Various Additives Used in the Stabilization of Expansive Soils
ASTM International

Books & Journals/Geotechnical Testing Journal/Citation Page/

Volume 25, Issue 2 (June 2002)

ISSN: 0149-6115
Published Online: 0 0
Page Count: 11

Click here to download this paper now

View License Agreement

A Comparative Evaluation of Various Additives Used in the Stabilization of Expansive Soils
Al-Rawas AA, Taha R, Nelson JD, Al-Shab TB, Al-Siyabi H
(Received 17 October 2000; accepted 6 September 2001)

Abstract
This paper investigates the effectiveness of using cement by-pass dust, copper slag, granulated blast furnace slag, and slag-cement in reducing the swelling potential and plasticity of expansive soils. The soil used in this study was brought from Al-Khod (a town located in Northern Oman) where structural damage was observed. The first stage of the experimental program dealt with the determination of the chemical, mineralogical, and geotechnical characteristics of the untreated soil. The soil was then mixed with the stabilizers at 3, 6, and 9% of the dry weight of the soil. The treated samples were subjected to liquid limit, plastic limit, swell percent, and swell pressure tests. Furthermore, the cation exchange capacity, exchangeable cations (Na+, Ca++, Mg++, and K+), and pH of the treated samples were also measured. The study showed that copper slag caused a significant increase in the swelling potential of the treated samples. Other stabilizers reduced the swelling potential and plasticity at varying degrees. The study further indicated that cation exchange capacity and the amount of sodium and calcium cations are good indicators of the effectiveness of chemical stabilizers used in soil stabilization.

Keywords:
expansive, soil, Soil stabilization, stabilizer, swelling

Paper ID: GTJ2520199

ASTM International is a member of CrossRef.
Author Al-Rawas AA, Taha R, Nelson JD, Al-Shab TB, Al-Siyabi H Title A Comparative Evaluation of Various Additives Used in the Stabilization of Expansive Soils Symposium , Committee on

 
Copyright © 1996-2007 ASTM. All Rights Reserved.
ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA, 19428-2959 USA